Universal Wallpaper Adhesive | AS Creation


Properties:

A.S. Universal Adhesive is resin-reinforced, high yielding,lime and cement resistant, and possesses an exceptional adhesion when adjusted. It dries out without marks (also on feshly dried plaster).

Preparation of Working Surface:

Remove all wallpaper remnants. The area to be papered must be dry, clean, firm, sustainable, flat and be only slightly porous. Cracks and holes need to be closed with filler using a spatula. A highly porous surface should be pasted according to the table.
 
Preparation:
Mix the packet contents well in cold water (see the table). Beat powerfully again 15 minutes later. After that the A. S. Universal Adhesive is ready for use. Do not allow excess adhesive to remain on the surface for too long.
 
Papering:
Paste the wall after paying attention to the instructions for use. If necessary, soak the wall and then paper. A. S. Universal Adhesive was specifically developed for A. S. and living walls products (paper, satin, structured profile and non-woven wall coverings).
Store dry and out of the reach of children.
 
Use  
Litres of water per packet
 
packet sufficient for Surface
Pre-pasting  
10
 
80-100 sqm
Wallpaper  
6
 
35-40 sqm
(7-8 Euro-rolls)
Satin-, structured profile- and non-woven coverings  
5
 
25-35 sqm
(5-7 Euro-rolls)
There is no rating for "Universal Wallpaper Adhesive | AS Creation" yet.
Please write the first review.
Captchar Image

Nach oben